HiCo Magnetic Stripe Roll

 

HiCo / LoCo Magnetic Stripe

Introduction
A plastic card with a magnetic stripe is capable of storing data by modifying the magnetism of the iron based particles that are found on the band of magnetic material on the plastic card. This magnetic stripe can be read by physical contact and swiping past a reading head. There are a number of standards which are used to define the physical properties of a plastic card determined by the International Organization for Standardization. These guidelines include the size, flexibility, location of the magnetic stripe, and magnetic characteristics. These standards regulate that the magnetic stripe is located 0.223 inches or 5.66mm from the edge of the plastic card and that the magnetic stripe is 0.375 inches or 9.52mm in width. Most plastic cards with magnetic stripes have the magnetic stripe contained in a plastic-like film and the magnetic stripe contains three tracks where each track is 0.110 inches or 2.79mm wide. Tracks one and three are usually recorded at 210 bits per inch or 8.27 bits per mm. Track two is typically recorded using a density of 75 bits per inch or 2.95 bits per mm. Tracks one and three can contain 5-bit numeric characters or 7-bit alphanumeric characters. Plastic cards which utilize these guidelines for their plastic cards can typically be read by most point of sale hardware. The types of plastic cards that adhere to these standards normally include bank cards, ATM cards, credit cards, membership cards, gift cards, loyalty cards, EBT cards (food stamps), and any application where the value or secure information is not stored on the plastic card itself. Plastic cards that do not need to follow these guidelines when formatting their magnetic stripes are plastic cards in which the balance or information is stored directly on the card such as hotel key cards, subway or bus cards, and prepaid calling cards.
Magnetic stripes fall into two main categories which are high-coercivity (HiCo) at 4000 Oe and low-coercivity (LoCo) at 300 Oe. However, it is possible and not infrequent to find magnetic stripes with the intermediate values at 2750 Oe as well. High Coercivity magnetic stripes are harder to erase and are well suited for use on plastic cards that are used frequently or that need to have a long life. Low Coercivity magnetic stripes on the other hand require a less amount of magnetic energy to record which means the card writers are much more cost efficient than that of machines which are capable of recording high-coercivity magnetic stripes. Low-coercivity magnetic stripes are almost always light brown in color while high-coercivity magnetic stripes are nearly black. High-coercivity stripes are more resistant to damage from most magnets that a consumer would be likely to own while low-coercivity magnetic stripes are easily damaged.

:


 




Description of products:
Hi-Co (high coercivity) is a type of magnetic stripe tape made up of magnetic particles that can stand under difficult operating environments the particles will not be easily affected when closing to a magnetic field

Specification:
  • length:1000±20m
  • liner thickness:12um
  • width:12.7±0mm
  • commodity: Hi-CO Magnetic Strip
  • 1090m×12.7mm---2750OE
  • unit: roll

 


Hi-Co Magnetic Stripe (2750OE
)

 



Application and features:
It is suitable to Phone cards, SIM cards, trade cards, time and attendance cards, meal cards and other PVC magnetic strip cards. Excellent heat-resistance, corrosion resistance functions, stick fast and hardly falls off. Suitable to press process.

General
Characteristics:
  • Backing tape: Polyester film
  • Magnetic Layer : Iron Oxide (Fe203)
  • Surface color: Black

Plastic Cards / Ribbons / Foils

Comparing Encoders


©Copyright 1999 To Present Escan-UK. All Rights Reserved